How to quickly master the operation points of the color master machine

How to quickly master the operation points of the color master machine

The action process of the metering color master machine is to control the signal to the motor to rotate, and then drive the screw through the coupling, so that the color master material in the hopper falls into the drop rod, is squeezed by the screw and is transported to the base by the screw, thus achieving the purpose of metering and transporting the color master material.

Metering color master machine commissioning method and metering master machine test operation process:

1. Turn on the power supply of the control box.

2. Determine the color of the product to be produced, press the "Set key to enter the "Working Parameters", change the screw number to the corresponding color, then save the set value, and enter the page ready for operation.

3. When color master machine starts running, it shows "Ready", the main machine starts and has been running, it will show "Running".

4. If it shows "Running changes to "Out of Material Stop", it indicates that the material level in the hopper is lower than the detection position, and a reminder is required to add master material.5. If there is a red light flashing warning, it is necessary to check the thermal relay, stirring shaft or motor.

6. Each key of the controller has basic operation: generally including: up arrow, down arrow, left arrow, right arrow, set key, run key, stop key.

The operation process of the metering color master machine simply introduced here.